Display Panel

Display Panel

The following information outlines the operation for a standard installation.

 

Buttons

Buttons Description

Slowly slide a finger across the buttons from left to right to disable the sleep mode.

Sleep mode will automatically reactivate after three minutes have passed.

Select either the pool or the spa thermostat.
Enter the user menu for heat pump options.
Used to increase temperature set point and navigate through menu options.
Used to decrease temperature set point and navigate through menu options.
Used to select the heat pump's operating mode. Also used to edit or confirm options in a menu.

Indicator Lights

Indicators Description
Heating Red LED indicates the unit is heating the water.
Cooling Blue LED indicates the unit is cooling the water.
When calling for heating or cooling, up to a three-minute delay may occur before the compressor starts. The compressor must be operating before the indicator will illuminate.

 

Display

  Display Description
Entry code required The heat pump has a user lock enabled. See "Using Entry Code to Access Heat Pump"
No water flow No water flow is detected. The filter pump is off or the heat pump is not receiving the correct water flow.
Primary Heat Pump Primary heat pump controlling other connected heat pumps
Remote Controlled - by primaryHeat Pump Heat Pump is set to be controlled by another connected heat pump.
Remote Controlled - by external controller Heat Pump is set to be controlled by an external controller.
Set to 75° F - Maintaining Maintaining a water temperature set on the thermostat. In this example, the pool thermostat has been set to 75° F.
Set to 45° F - Cooling Cooling water to point set on the thermostat. In this example, the pool thermostat has been set to 45° F.
Set to 75° F - Heating Heating water to point set on the thermostat. In this example, the pool thermostat has been set to 75° F.
Set to Off The heat pump has been deactivated using the "Mode / Enter" button.